NW Natural

What is covered in your NW Natural Tune Up

 

20 Point Gas Furnace Tune Up

  • Cycle the furnace
  • Limited blower cleaning
  • Clean or change filter (customer supplied or purchased from contractor)
  • Verify limit operations
  • Measure and record delta T
  • Clean flame sensor
  • Cycle condensate pump (90% or better EF)
  • Measure and record amp draw to blower
  • Rate/set furnace input
  • Measure and record amp draw inducer
  • Inspect flue pipe
  • Measure and verify ignition protocols
  • Clean burners
  • Tighten electrical connections
  • Clean and adjust pilot assembly
  • Clean exterior
  • Measure and adjust gas pressure
  • Brush and inspect heat exchanger
  • Conduct bubble test for gas leaks
  • Vacuum burner compartment

11 Point A/C Tune Up

  • Cycle the air conditioner
  • Test total refrigerant pressure
  • Test outdoor ambient temperature
  • Test indoor ambient temperature test
  • Test amperage draw on fan motors
  • Oil motors
  • Check integrity of electrical contactors
  • Tighten electrical connections
  • Check indoor coils (drain properly)
  • Inspect and wash outdoor coils
  • Change fuses

17 Point Fireplace Tune Up

  • Check and clean pilot assembly
  • Check igniter
  • Test thermocouple/pile voltage
  • Check and clean burners
  • Limited blower cleaning
  • Check current to gas control valve
  • Check for proper on/off switch and t-stat operation
  • Check gas pressure
  • Check for gas leaks
  • Ensure proper safety switch operation
  • Check vent for blockage
  • Check for spillage at flue
  • Check and clean glass door and gaskets
  • Check gas log condition (if applicable)
  • Check remote control functionality
  • Touch up firebox paint
  • Replace ember bed material